Tektronix DPO70000 Series Programmer's Manual

Commands Listed in Alphabetical Order
EITher specifie
s either positive or negative polarity.
Examples
SEARCH:SEARCH1:TRIGGER:A:T RANSITION:POLARITY:MATH2 NEGATIVE
sets the Math 2 waveform transition trigger polarity setting for search 1 to
NEGATIVE.
SEARCH:SEARCH1:TRIGGER:A:T RANSITION:POLARITY:MATH1? might
return
:SEARCH:SEARCH1:TRIGGER:A:T RANSITION:POLARITY:MATH1
POSITIVE
, indicating that the Math 1 waveform transition trigger polarity setting
for search 1 is set to POSITIVE.
SEARCH:SEARCH<x>:TRIGger:A:TRANsition:POLarity:REF<x>
This command sets or queries the polarity setting for a transition trigger search
to determine where to place a mark. <x> is the search number or reference
waveform number.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger:A :TRANsition:POLarity:REF<x>
{EITher|NEGAtive|POSITIVe}
SEARCH:SEARCH<x>:TRIGger:A :TRANsition:POLarity:REF<x>?
Arguments
POSitive specifies that a pulse edge must traverse from the lower (most
negative) to higher (most positive) level for transition triggering to occur.
NEGative specifies that a pulse edge must traverse from the upper (most positive)
to lower (most negative) level for transition triggering to occur.
EITher specifies either positive or negative p olarity.
Examples
SEARCH:SEARCH1:TRIGGER:A:T RANSITION:POLARITY:REF2 N EGATIVE
sets the Reference 2 waveform transition trigger polarity setting for search 1 to
NEGATIVE.
SEARCH:SEARCH1:TRIGGER:A:T RANSITION:POLARITY:REF1? might return
:SEARCH:SEARCH1:TRIGGER:A: TRANSITION:POLARITY:REF1 POSITIVE,
indicating that the Reference 2 waveform transition trigger polarity setting for
search 1 is set to POSITIVE.
DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual 2-473

Tektronix DPO70000 Series Specifications

General

Brand	Tektronix
Model	DPO70000 Series
Category	Test Equipment
Language	English