Commands Listed in Alphabetical Order
WFMInpre:XINcr
This command sets or queries the horizontal interval between incoming waveform
points in units specified by WFMInpre:XUNit.
Group
Waveform Transfer
Syntax
WFMInpre:XINcr <NR3>
WFMInpre:XINcr?
Related Commands
WFMInpre:XUNit, WFMOutpre:XINcr?
Arguments
<NR3> is the horizontal interval representation.
Examples
WFMINPRE:XINCR 3E-3 sets the interval between Incoming waveform points
to3ms.
WFMINPRE:XINCR? might return :WFMINPRE:XINCR 1.0000E-3, indicating
that if WFMInpre:XUNit is set to “s”, there is a 1 ms interval between incoming
waveform points.
WFMInpre:XUNit
This command sets or returns the horizontal units of the incoming waveform.
Group
Waveform Transfer
Syntax
WFMInpre:XUNit <QString>
WFMInpre:XUNit?
Related Commands
WFMOutpre:XUNit?
Arguments
<QString> contains a maximum of three alpha characters that represent the
horizontal unit of measure for the incoming waveform.
Examples
WFMINPRE:XUNIT "HZ" specifies that the horizontal units for the incoming
waveform are hertz.
WFMINPRE:XUNIT? might return :WFMINPRE:XUNIT "s", indicating that the
horizontal units for the incoming waveform are seconds.
DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual 2-635
To Next Page
Loading...
Need help?
General
