Commands Listed in Alphabetical Order
A 0 returns mini
mum-length keywords for applicable setting queries; any other
value returns full-length keywords.
Examples
VERBOSE ON sets the Verbose state to true and return the full length keyword for
the applicable setting queries.
VERBOSE? might return :VERBOSE 0FF, indicating that the Verbose state is set to
false and return the minimum-length keywords for the applicable setting queries.
*WAI (No Query Form)
The *WAI (Wait) command (no query form) prevents the instrument from
executing further commands or queries until all pending commands that generate
an OPC message are complete. This command allows you to synchronize the
operation of the instrument with your application program. For more information,
refer to Synchronization Methods.
Group
Status and Error
Syntax
*WAI
Related Commands
BUSY?, *OPC
Examples
*WAI prevents the instrument from executing any further commands or queries
until all pending commands that generate an OPC message are complete.
WAVFrm? (Query Only)
This query-only command returns WFMOutpre? and CURVe? data for the
waveform as specified by the DATA:SOUrce command. This command is
equivalent to sending both WFMOutpre? and CURVe?, with the additional
provision that the response to WAVFrm? is guaranteed to provide a synchronized
preamble and curve.
Group
Waveform Transfer
Syntax
WAVFrm?
Related Commands
CURVe, DATa:SOUrce, WFMOutpre?
2-626 DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual
To Next Page
Loading...
Need help?
General
