Tektronix DPO70000 Series Programmer's Manual

Commands Listed in Alphabetical Order
Arguments
FALL specifies p
olarity as the clock falling edge.
RISe specifi es polarity as the clock rising edge.
Examples
SEARCH:SEARCH1:TRIGGER:A: STATE:CLOCk:EDGE? RISE sets the state
trigger clock slope polarity setting for search 1 to RISE.
SEARCH:SEARCH1:TRIGGER:A: STATE:CLOCk:EDGE? might return
:SEARCH:SEARCH1:TRIGGER:A :STATE:CLOCk:EDGE FALL, indicating that
the state trigger clock slope polarity setting for search 1 is s et to FALL.
SEARCH:SEARCH<x>:TRIGger:A:STATE:CLOCk:SOUrce
This command sets or queries the clock source of the twelve waveforms for a state
trigger search to determine where to place a mark. <x> is the search number. The
hardware trigger is always on the channel 4.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger: A:STATE:CLOCk:SOUrce
{CH1|CH2|CH3|CH4|MATH1|MA TH2|MATH3|MATH4|REF1|REF2|REF3|REF4}
SEARCH:SEARCH<x>:TRIGger: A:STATE:CLOCk:SOUrce?
Arguments
CH<x> specifies an input channel as the search source, where <x> = 1, 2, 3 or 4.
MATH<x> specifies the math waveform as the search source, where <x> = 1, 2, 3
or 4.
REF<x> specifies the reference waveform as the se arch source, where <x> =
1, 2, 3 or 4.
Examples
SEARCH:SEARCH1:TRIGGER:A: STATE:CLOCK:SOURCE CH2 sets the state
trigger clock source for search 1 to Channel 2.
SEARCH:SEARCH1:TRIGGER:A: STATE:CLOCK:SOURCE? might return
:SEARCH:SEARCH1:TRIGGER:A :STATE:CLOCK:SOURCE CH1, indicating that
the state trigger clock source for search 1 is set to Channel 1.
SEARCH:SEARCH<x>:TRIGger:A:STATE:WHEn
This command sets or queries
the state trigger search to determine where to place
amark.
<x> is the search number.
Group
Search and Mark
2-468 DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual

Tektronix DPO70000 Series Specifications

General

Brand	Tektronix
Model	DPO70000 Series
Category	Test Equipment
Language	English