Commands Listed in Alphabetical Order
Syntax
RECAll:WAVEfo
rm <file path>,REF<x>
Related Commands
DELEte:WAVEform, SAVe:WAVEform
Arguments
REF<x> specifies a location in internal reference memory. Reference memory
location values range from 1 through 4.
<file p ath> specifies a location for a stored waveform file. <file path> is a
quoted string that defines the file name and path. Input the file path using the
form <drive>:<dir>/<filename>.<drive> and one or more <dir>s are optional. If
you do not specify them, the instrument will read the waveform from the default
directory (C:\TekScope|Waveforms). <filename> stands for a filename of up
to 128 characters (use of wildcard characters in filenames is not supported).
Filename extensions are not required but are highly recommended.
Examples
RECALL:WAVEFORM "TEK00000. WFM",REF1 recalls the waveform stored
in the file named TEK00000.WFM from the default directory for waveforms
(C:\TekScope\Waveforms) to the reference location 1.
REF<x>:HORizontal:POSition
This command sets or queries the horizontal display position of the reference
waveform. The reference waveform is specified by x. The value of x can range
from 1 through 4. This command is equivalent to selecting Reference Wave forms
from the File menu, choosing Reference Setup¼ from the drop-down list,
selecting a reference waveform, and then entering the horizontal position value
using the multipurpose knob.
Group
Vertical
Syntax
REF<x>:HORizontal:POSition <NR3>
REF<x>:HORizontal:POSition ?
Arguments
<NR3> argument specifies the horizontal position of the specified reference
waveform in percentage of the waveform that is displayed to the right of the
center vertical graticule. The range
of this argument is from 0 through 100.
Examples
REF2:HORIZONTAL:POSITION 0.0 positions the start of the Reference 2
waveform at the center graticule.
DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual 2-417
To Next Page
Loading...
Need help?
General
