Commands Listed in Alphabetical Order
MEASUREMENT:A
NNOTATION:TYPE?
might return
:MEASUREMENT:ANNOTATION:T YPE STANDARD, indicating that standard
annotations will be displayed.
MEASUrement:ANNOTation:X<x>? (Query Only)
This query-only command returns the value of the specified X annotation. X
annotations are numbered, in general, from top to bottom on the display. The
value of <x> can vary from 1 to 6.
Group
Measurement
Syntax
MEASUrement:ANNOTation:X< x>?
Examples
MEASUREMENT:ANNOTATION:X1 ? might return
:MEASUREMENT:ANNOTATION:X 1 277.2250E-12 , indicating that annotation
X1 is 277 ps to the right of the trigger.
MEASUrement:ANNOTation:Y<x>? (Query Only)
This query-only command returns the value of the specified Y annotation. Y
annotations are numbered, in general, from left to right on the display. The value
of <x> can vary from 1 to 6.
Group
Measurement
Syntax
MEASUrement:ANNOTation:Y< x>?
Examples
MEASUREMENT:ANNOTATION:Y1 might return
:MEASUREMENT:ANNOTATION:X 1 305.6406E-3,, indicating that a nnotation
Y1 is 305 mV above the c hannel reference.
MEASUrement:GATing
This command specifies or returns the measurement gating setting. This command
is equivalent to selecting Gating from the Measure menu and then clicking the
desired Measurement Gating setting.
Group
Measurement
2-366 DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual
To Next Page
Loading...
Need help?
General
