Suzuki LS650 Savage User Manual

REAR SUSPENSION
the holes in the frame. To help align the holes.
inse rt a drift in from the righI-hand side.
3. Apply a light COal of molybdenum disulfide
grease to the pivot bolt and install the pivot bolt
from the left-hand side.
4. In stall the se lf -locking nUl and tighten to the
torque specification listed in Table I.
5. Move thc swing arm up and down several times
10 make sure all components are properly scaled.
6. In sert Ihe brake cable through thc receptacle in
th e swing arm and tighten Ih e locknut.
7. In sta ll the rear wheel as described in this
chapter.
8. In stall the drive belt as described in this chapter.
®
SWING ARM ASSEMBLY
8
295
9. In stall the shock absorbers as described in this
chapter.
1 0. Install the cap on each si de of the frame
covering the pivot bolt and nut.
11. Adjust Ih e drive belt as described in Chapter
Thr ee.
12. Adjust the rear brake as described under R ea r
Brake
Pedal Height and Freeplay Adjustmem in
Chapter Three.
Disassembly/Inspection/Assembly
Refer to Figure 55 for th is procedure.
6 7 8 1
I
, ~'------ .
~qJC~Cft-1
13 14 15 14 13
1. Washer
9. Swing arm
2. Cap nut 10. Pivot bolt
3. Shock absorber
11. Drive belt lower guard
4. Shoulder boll
12. Screw
5. Bolt
13. Pivot apacer
6. Cap
14 . Needle bearing
7. Plvol bolt nut 15. Distance collar
8. Dust seal 16. Drive belt upper guard

Suzuki LS650 Savage Specifications

General

Displacement	652 cc
Bore x Stroke	94.0 mm x 94.0 mm
Compression Ratio	8.5:1
Fuel System	Carburetor
Ignition	Electronic ignition (CDI)
Transmission	5-speed constant mesh
Final Drive	Belt
Front Brakes	Single disc
Rear Brakes	Drum
Front Tire	100/90-19
Rear Tire	140/80-15
Front Suspension	Telescopic
Rear Suspension	Swingarm type, coil spring, oil damped
Seat Height	700 mm (27.6 in)
Overall Length	2180 mm
Ground Clearance	140mm (5.5 inches)
Engine Type	4-stroke, air-cooled, SOHC
Wheelbase	1480 mm