Hydro:Evolved User Manual
October 2022 © 2022 Smartrise Engineering, Inc. All Rights Reserved Page 99
10 Learning The Hoistway
Prior to learning the hoistway, verify the number of floors and openings are correct. See section
12.8 Floor Openings.
The following procedure describes how to learn the hoistway.
Bring the car to the top or bottom floor terminal.
Check the top right corner of the Main screen to verify the DZ input to the CT board is
high by.
Figure 113: Check Status by Main Screen Method
On the MR board, turn on DIP 5A.
The Main screen changes from Normal to Hold UP/DN To Start.
NOTE: Verify the Fire Service signals are active, or the elevator will go into fire service
after the Hoistway learn is complete.
Figure 114: Normal to Hold UP/DN To Start
Is the car at the top landing or bottom landing?
• If the car is at the top landing, hold Enable and Down until the car starts moving.
• If the car is at the bottom landing, hold Enable and Up until the car starts moving.
When the car stops, the screen shows Learn Complete.
Figure 115: Learn Complete
On the MR board, turn off DIP 5A.
To Next Page
Loading...
Need help?
General
