Hydro:Evolved User Manual
October 2022 © 2022 Smartrise Engineering, Inc. All Rights Reserved Page 237
28.6 ldle Timer
The idle timer is set to depict the amount of time the car stays in swing operation after all calls
have been serviced. The setup for inputs is required. If the inputs are not setup for the
controller, see section 28.1 Configuring Swing Operation Input.
The following procedure describes how to configure the idle timer.
Navigate to MAIN MENU | SETUP | SWING. See Figure 59.
From the SWING menu, scroll and select Idle Timer.
Figure 434: SWING Menu – Idle Timer
From the IDLE TIMER menu, set the time the car stays idle.
Figure 435: IDLE TIMER Menu
Scroll right and press Save.
29 Timer
Timers are used for energy conservation.
29.1 Fan & Light Timer
The fan and light timer is the amount of time the fan and lights are on.
The following procedure describes how to set the time the fan and lights are on.
Navigate to MAIN MENU | SETUP | MISCELLANEOUS. See Figure 57.
To Next Page
Loading...
Need help?
General
