Hydro:Evolved User Manual
Page 126 © 2022 Smartrise Engineering, Inc. All Rights Reserved October 2022
The following procedure describes how to set the preopening distance.
Navigate to MAIN MENU | SETUP | DOOR SETUP. See Figure 55.
From the DOORS menu, scroll and select PreOpening Distance.
Figure 198: DOORS Menu – PreOpening Distance
From the PREOPENING DISTANCE menu, set the distance from the landing the doors
start to open.
Figure 199: PREOPENING Distance Menu
Scroll right and press Save.
14.11 DC On Run
The DC On Run activates a door close output when the car is in motion. This can be useful if
doors require constant pressure to prevent relaxing.
The following procedure describes how to set the DC on Run.
Navigate to MAIN MENU | SETUP | DOOR SETUP. See Figure 55.
From the DOORS menu, scroll and select DC On Run.
Figure 200: DOORS Menu – DC On Run
From the DC ON RUN menu, scroll and select ON to enable the doors to close when the
car is in motion.
Figure 201: DC ON RUN Menu
To Next Page
Loading...
Need help?
General
