Hydro:Evolved User Manual
October 2022 © 2022 Smartrise Engineering, Inc. All Rights Reserved Page 229
When the system has completed defaulting all parameters, the DEFAULTING
PARAMETERS menu displays Parameters Defaulted as shown in the figure below.
Figure 413: DEFAULTING PARAMETERS Menu – Parameters Defaulted
27.13.2 Default S-Curve
The user has the option restore the original S-Curve.
The following procedure describes how to select default S-Curve.
Navigate to MAIN MENU | SETUP | MISCELLANEOUS. See Figure 57.
From the MISCELLANEOUS menu, scroll and select Default. Figure 409.
From the DEFAULT menu, scroll and select Default S-Curve.
Figure 414: DEFAULT Menu – Default S-Curve
From the DEFAULT S-CURVE? menu, select if restoring original S-Curve.
Figure 415: DEFAULT S-CURVE? Menu
From the DEFAULT S-CURVE? menu, select Yes to default S-Curve.
NOTE: If not defaulting S-Curve, select NO to back out.
The system automatically defaults all parameters. See Figure 412.
When the system has completed defaulting all parameters, the DEFAULTING
PARAMETERS menu displays PARAMETERS DEFAULTED. See Figure 413.
27.13.3 Default Run Timers
The user has the option to restore the original run timers.
The following procedure describes how to select default run timers.
Navigate to MAIN MENU | SETUP | MISCELLANEOUS. See Figure 57.
To Next Page
Loading...
Need help?
General
