Hydro:Evolved User Manual
Page 38 © 2022 Smartrise Engineering, Inc. All Rights Reserved October 2022
The table below lists the Setup – Setup I/O, Safety, and Run Timers menu structures.
Table 15: Setup – Setup I/O, Safety and Run Timers Menu Structures
Allows the user to setup the elevator configuration
Configure inputs and outputs
Allows the user to adjust safety related functions
Adjust start sequence and stop sequence timers
Change state of input to the MR board
Change state of input to the CT board
Change state of input to the COP board
Change state of input to the Riser board
Change state of input to the Expansion 1-8 boards
Change state of input to the Expansion 9-16 boards
Change state of input to the Expansion 17-24 boards
Change state of input to the Expansion 25-32 boards
Change state of input to the Expansion 33-40 boards
Change state of output to the MR board
Change state of output to the CT board
Change state of output to the COP board
Change state of output to the Riser board
Change state of output to the Expansion 1-8 boards
Change state of output to the Expansion 9-16 boards
Change state of output to the Expansion 17-24 boards
Change state of output to the Expansion 25-32 boards
Change state of output to the Expansion 33-40 boards
Assign inputs to the MR board
Assign inputs to the CT board
Assign inputs to the COP board
Assign inputs to the Riser board
Assign inputs to the Expansion 1-8 boards