Hydro:Evolved User Manual
Page 236 © 2022 Smartrise Engineering, Inc. All Rights Reserved October 2022
From the GROUP SETUP menu, scroll and select Swing Call Mask.
Figure 430: GROUP SETUP Menu – Swing Call Mask
From the HALL SWING MASK menu, scroll and select the cars set for swing operation.
Figure 431: HALL SWING MASK Menu
Scroll right and press Save.
28.5 Stay Active in Group
When a car is setup to stay active in the group, the car can be operated by any riser in the
system during swing operation. The setup for inputs is required. If the inputs are not setup for
the controller, see section 28.1 Configuring Swing Operation Input.
The following procedure describes how to configure the car to stay active in the group.
Navigate to MAIN MENU | SETUP | SWING. See Figure 59.
From the Swing menu, scroll and select Stay In Group.
Figure 432: SWING Menu – Stay In Group
From the STAY IN GROUP menu, scroll and select On.
Figure 433: STAY IN GROUP Menu
Scroll right and press Save.
To Next Page
Loading...
Need help?
General
