Hydro:Evolved User Manual
October 2022 © 2022 Smartrise Engineering, Inc. All Rights Reserved Page 177
Scroll right and press Save.
18.4.3.2 Relevel Offset
Relevel Offset is the distance from the destination position that the car cuts its leveling valve
when moving in the up or down direction on a releveling run.
Perform the following procedure to set the up or down offset.
Navigate to MAIN MENU | SETUP | HYDRO. See Figure 60.
From the HYDRO SETUP menu, scroll and Relevel Offset Up or Down. The values are set
after determing how far the cars have overshot the landing.
Figure 312: HYDRO SETUP Menu – Relevel Offset (Up or Down)
From the RELEVEL OFFSET UP or RELEVEL OFFSET DOWN menu, enter the offset. The
values are set after determing how far the cars have overshot the landing.
Figure 313: RELEVEL OFFSET UP Menu
Figure 314: Relevel Offset Down Menu
Scroll right and press Save.
18.4.4 Speed Thresholds
The speed threshold is compared to the current speed to determine the slowdown distance
used to reach the destination. This distance determines when to slow the car in either the up or
down direction.
The following procedure describes how to set the speed threshold.
Navigate to MAIN MENU | SETUP | HYDRO. See Figure 60.
To Next Page
Loading...
Need help?
General
