Hydro:Evolved User Manual
Page 300 © 2022 Smartrise Engineering, Inc. All Rights Reserved October 2022
From the Hall Mask Status (see Figure 243), view the status and press the right button.
From the Front Opening Map Status (see Figure 244), view the status and press the right
button.
From the Rear Opening Map Status (see Figure 245), view the status and press the right
button.
From the Emergency Power Status, view the status and press the right button.
Figure 588: Emergency Power Status Menu
From the Fire Emergency Power Status, view the status.
Figure 589: Fire Emergency Power Status Menu
35 PI Labels
The position indicator (PI) label allows the user to label any landing with a 2-digit alpha-numeric
identifier. To allow for 3-digit alpha-numeric identifiers, see section 27.10 En. 3 Digit PI.
The following procedure describes how to set the position indicator labels.
Navigate to MAIN MENU | SETUP | PI LABELS. See Figure 57.
From the SET PI LABEL menu, scroll and select the floor indicator label.
Figure 590: SET PI LABEL Menu
Scroll right and press Save.
36 Attendant
Attendant operation is an automatic mode of operation in which an attendant manually
operates the car. The attendant has an up and down lamp in the car indicating if there are hall
calls latched above or below the car’s current floor. The attendant uses these lamps, and as
well as UP and DOWN direction buttons, which control the next direction of the car, to pick up
To Next Page
Loading...
Need help?
General
