1I-8 Starting System:
Side-stand / Ignition Interlock System Parts
Inspection
B823H11906008
Check the interlock system for proper operation. If the
interlock system does not operate properly, check each
component for damage or abnormalities. If any
abnormality is found, replace the component with a new
one.
Side-stand Switch
1) Turn the ignition switch OFF.
2) Remove the engine sprocket outer cover. Refer to
“Exterior Parts Removal and Installation in Section
9D (Page 9D-14)”.
3) Disconnect the side-stand switch coupler (1).
4) Measure the voltage between G and B/W lead wires.
Special tool
: 09900–25008 (Multi-circuit tester set)
Tester knob indication
Diode test ( )
NOTE
If the tester reads 1.4 V and below when the
tester probes are not connected, replace its
battery.
5) Connect the side-stand switch coupler.
6) Install the engine sprocket outer cover. Refer to
“Exterior Parts Removal and Installation in Section
9D (Page 9D-14)”.
Turn Signal / Side-stand Relay
The turn signal/side-stand relay is composed of the turn
signal relay, side-stand relay and diode.
Side-stand relay
1) Remove the turn signal/side-stand relay. Refer to
“Turn Signal / Side-stand Relay Removal and
Installation (Page 1I-7)”.
2) Check the insulation between “D” and “E” terminals
using the multi-circuit tester.
3) Apply 12 V to terminals “D” and “C” ((+) to “D” and (–
) to “C”) and check the continuity between “D” and
“E”. If there is no continuity, replace the turn signal/
side-stand relay with a new one.
Special tool
: 09900–25008 (Multi-circuit tester set)
Tester knob indication
Continuity test ( )
G
((+) probe)
B/W
((–) probe)
ON
(Side-stand up)
0.4 – 0.6 V
OFF
(Side-stand down)
1.4 V and more
(Tester’s battery voltage)
1
I823H1190013-01
I823H1190014-01
I649G1190027-02
DIODE
SIDE-STAND RELAY
TURN
SIGNAL
RELAY
“A”“B”“C”“D”
“E” “F” “G”
“A” “B” “C” “D” “E” “F” “G”
I649G1190028-02
To Next Page
Loading...
Need help?
General
