0B-15 Maintenance and Lubrication:
3) Inspect the clutch hose for crack, damage or clutch
fluid leakage. If it is damaged, replace the clutch
hose with a new one.
4) After finishing the clutch hose inspection, reinstall
the removed parts.
Clutch Hose Replacement
B823H10206015
Replace clutch hose
Every 4 years
Refer to “Clutch Hose Removal and Installation in
Section 5C (Page 5C-6)”.
Clutch Fluid Replacement
B823H10206016
Replace clutch fluid
Every 2 years
Refer to “Clutch Fluid Replacement in Section 5C
(Page 5C-5)”.
Air Bleeding from Clutch Fluid Circuit
Refer to “Air Bleeding from Clutch Fluid Circuit in Section
5C (Page 5C-5)”.
Drive Chain Inspection and Adjustment
B823H10206017
Inspect drive chain
Initially at 1 000 km (600 miles, 2 months) and every
6 000 km (4 000 miles, 12 months) thereafter
Drive Chain Visual Check
1) With the transmission in neutral, support the
motorcycle using a jack and turn the rear wheel
slowly by hand.
2) Remove the engine sprocket inner cover. Refer to
“Engine Sprocket Removal and Installation in
Section 3A (Page 3A-2)”.
3) Visually check the drive chain for the possible
defects listed as follows. If any defects are found, the
drive chain must be replaced. Refer to “Drive Chain
Replacement in Section 3A (Page 3A-7)”.
• Loose pins
• Damaged rollers
• Dry or rusted links
• Kinked or binding links
• Excessive wear
• Improper chain adjustment
• Missing O-ring seals
NOTE
When replacing the drive chain, replace the
drive chain and sprockets as a set.
4) Inspect the sprocket cover protector (3). If any
defects are found, replace the protector.
5) Install the removed parts.
I823H1020062-02
I823H1020065-01
1. O-ring seal 2. Grease
2
1
I649G1020032-02
3
I823H1020046-01
To Next Page
Loading...
Need help?
General
