Brake Control System and Diagnosis: 4A-15
Rear Brake Master Cylinder Disassembly and
Assembly
B823H14106017
Refer to “Front Brake Master Cylinder Assembly
Removal and Installation (Page 4A-10)”.
Disassembly
1) Disconnect the reservoir hose (1).
2) Remove the lock-nut (2).
3) Remove the snap ring (3), brake hose connector (4)
and O-ring (5).
Special tool
: 09900–06108 (Snap ring pliers)
4) Pull out the dust boot (6) and remove the snap ring
(7).
Special tool
: 09900–06108 (Snap ring pliers)
5) Remove the push rod (8), piston/cup set (9) and
spring (10).
Assembly
Assemble the master cylinder in the reverse order of
disassembly. Pay attention to the following points:
CAUTION
!
• Wash the master cylinder components with
new brake fluid before reassembly.
• Do not wipe the brake fluid off after
washing the components.
• When washing the components, use the
specified brake fluid. Never use different
types of fluid or cleaning solvents such as
gasoline, kerosine, etc.
• Apply brake fluid to the master cylinder
bore and all of the master cylinder
component to be inserted into the bore.
BF: Brake fluid (DOT 4)
1
2
I823H1410038-02
4
3
5
I823H1410039-01
6
7
I823H1410040-01
8
9
10
I823H1410041-02
I649G1410036-02
To Next Page
Loading...
Need help?
General
