10E-20 Keyless Start System:
Key Indicator Lamp Circuit Check (Key indicator lamp doesn’t light when ignition knob switch is
pushed.)
S7RS0BA504015
Wiring Diagram
Description
When the ignition knob switch is pushed, the key indicator lamp lights up in blue if you carry the remote controller
registered in the keyless start control module and it lights in red if you carry the remote controller which has not been
registered in the keyless start control module or if you carry no remote controller.
G42-14
G42-20
G42-29
G42-30
G42-34
WHT/RED
WHT/RED
5V
5V
5V
5V
BLK/ORN
G42-9
G42-15
G42-10
G42-11
BLU/WHT
WHT/RED
WHT/RED
RED/BLK
5V
12V
WHT
RED
WHT
RED
G42-18
G42-19
G28-9
G28-7
G28-32
BLU/YEL
ORN
BLK/YEL
BRN/YEL
BRN
G22-3
G22-1
G22-2
G22-5
G22-4
G22-6
G22-7
G22-8
WHT/RED
WHT/RED
1234567891011141516
36 34 33 32 31 30 29 24 2337
181920
1
2
4
5
7
6
[A]
3
I5RS0CA50005-01
[A]: Keyless start control module connector (viewed from harness side) 4. Steering lock unit
1. Keyless start control module 5. Steering lock solenoid
2. Combination meter 6. Key reminder switch
3. Key indicator lamp 7. Ignition knob switch