Fuel System: 1G-16
Removal
1) Remove fuel pump assembly from fuel tank referring
to “Fuel Pump Assembly Removal and Installation”.
2) Disconnect main fuel level sensor connector (3).
3) With pressing snap-fit part (2), remove main fuel
level sensor (1) by sliding it in the arrow direction as
shown in figure.
Installation
Reverse removal procedure for installation.
Fuel Pump Inspection
S7RS0B1706019
• Check fuel pump assembly for damage.
• Check fuel suction filter for evidence of dirt and
contamination. If present, replace or clean and check
for presence of dirt in fuel tank.
• For electrical circuit, refer to “Fuel Pressure Check in
Section 1A”.
• For inspection of main fuel level sensor (1), refer to
“Fuel Level Sensor Inspection in Section 9C”.
Specifications
Tightening Torque Specifications
S7RS0B1707001
NOTE
The specified tightening torque is also described in the following.
“Fuel System Components”
“Fuel Hose Disconnecting and Reconnecting”
Reference:
For the tightening torque of fastener not specified in this section, refer to “Fasteners Information in Section 0A”.
1
2
1
3
I5RS0D170006-03
1
I5RS0D170008-01
Fastening part
Tightening torque
Note
N⋅mkgf-mlb-ft
Fuel delivery pipe bolt 25 2.5 18.0 )
Ground wire bolt 11 1.1 8.0 )
Fuel tank bolt 45 4.5 33.0 )
Fuel filler hose clamp 2 0.2 1.5 )
Fuel pump assembly bolt 11 1.1 8.0 )
To Next Page
Loading...
Need help?
General
