EasyManuals Logo

Suzuki Swift Sport 2004 User Manual

Suzuki Swift Sport 2004
1496 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #284 background imageLoading...
Page #284 background image
1C-12 Engine Electrical Devices:
MAF and IAT Sensor Inspection
S7RS0B1306020
CAUTION
!
Do not heat up MAF and IAT sensor more
than 100 °C (212 °F). Otherwise, MAF and IAT
sensor will be damaged.
Check sensor O-ring (1) for damage and
deterioration. Replace as necessary.
Blow hot air to temperature sensing part (2) of MAF
and IAT sensor (3) using hot air drier (4) and measure
resistance between sensor terminals while heating air
gradually.
If measured resistance does not show such
characteristic as shown, replace MAF and IAT sensor.
IAT sensor resistance
–20 °C (–4 °F): 13.6 – 18.4 k
20 °C (68 °F): 2.21 – 2.69 k
60 °C (140 °F): 0.493 – 0.667 k
Electric Load Current Sensor On-Vehicle
Inspection
S7RS0B1306021
Using SUZUKI Scan Tool
1) Connect scan tool to DLC with ignition switch turned
OFF.
2) Check “Battery Current” displayed on scan tool at
following condition.
Battery current
Ignition switch ON: 6.5 – 7.5 A
Ignition switch ON, headlight ON: 18.6 – 19.1 A
Ignition switch ON, headlight ON and blower
motor switch is HI position: 27.1 – 27.6 A
Engine running at idle speed, headlight ON,
blower motor switch is HI position and rear
defogger switch ON: 38.1 – 41.7 A
If check result is satisfactory, electric load current sensor
is in good condition.
If check result is not satisfactory, check the following
parts and circuit.
Electric load current sensor circuit (power, ground and
output)
Following charging system components
Battery (refer to “Battery Inspection in Section 1J”)
Generator (refer to “Generator Inspection in
Section 1J”)
Generator output control circuit (refer to “Generator
Test (Undercharged Battery Check) in Section 1J”)
Generator field coil monitor circuit (refer to
“Generator Inspection in Section 1J”)
If electric load current sensor circuit and charging
system is in good condition, electric load current sensor
(1) is faulty.
[A]: Lower limit [D]: Resistance
[B]: Nominal [E]: Temperature
[C]: Upper limit 5. Temperature gauge
200
6832 104 140 176
40 60 80
(2.45)
(0.58)
1
2
3
4
5
[A]
[B]
[E]
[C]
[D]
I4RS0A130012-01
2. Main fuse box
2
1
I5RS0C130001-01

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Suzuki Swift Sport 2004 and is the answer not in the manual?

Suzuki Swift Sport 2004 Specifications

General IconGeneral
BrandSuzuki
ModelSwift Sport 2004
CategoryAutomobile
LanguageEnglish

Related product manuals