Engine Mechanical: 1D-44
Pistons, Piston Rings, Connecting Rods and Cylinders Components
S7RS0B1406029
1. Top ring 6. Connecting rod bearing cap
: See “B”
: Tighten15 N⋅m (1.5 kgf-m, 11.0 lb-ft), 45°
and 45° by the specified procedure.
2. 2nd ring 7. Connecting rod bearing : Apply engine oil to sliding surface of each
part.
3. Oil ring 8. Piston pin : Do not reuse.
4. Piston 9. Piston pin circlip
5. Connecting rod
: See “A”
10. Connecting rod bearing cap bolt
: See “C”
“A”: Apply engine oil to sliding surface except inner surface of big end.
“B”: Point arrow mark on cap to crankshaft pulley side.
“C”: Make sure bearing cap bolt diameter when reuse it due to plastic deformation tightening. Refer to “Piston Pins and Connecting Rods Inspection”.
(a)
1
2
3
9
4
5
6
10
7
8
9
OIL
OIL
OIL
OIL
OIL
OIL
OIL
OIL
OIL
I6RS0C140021-02