Commands listed in alphabetical order
Arguments
<NR1> =0stopsa
cquisitions; any other value starts acquisitions.
OFF stops acquisitions.
ON starts acquisitions.
RUN starts acquisitions.
STOP stops acquisitions.
Examples
ACQUIRE:STATE RUN starts the acquisition of waveform data and resets the count
of the number of acquisitions.
ACQUIRE:STATE? might return :ACQUIRE:STATE 0, indicating that the
acquisition is stopped.
ACQuire:STOPAfter
This command sets or queries whether the instrument continually acquires
acquisitions or acquires a single sequence. Pressing SINGLE on the front
panel button is equivalent to sending these c ommands:
ACQUIRE:STOPAFTER
SEQUENCE
and ACQUIRE:STATE 1.
Group
Acquisition
Syntax
ACQuire:STOPAfter {RUNSTop|SEQuence }
ACQuire:STOPAfter?
Related Commands
ACQuire:STATE
Arguments
RUNSTop specifies that the instrument will continually acquire data, if
ACQuire:STATE is turned on.
SEQuence specifies that the next acquisition will be a single-sequence acquisition.
Examples
ACQUIRE:STOPAFTER RUNSTOP sets the instrument to continually acquire data.
ACQUIRE:STOPAFTER? might return :ACQUIRE:STOPAFTER SEQUENCE,
indicating that the next acquisition the instrument makes will be of the
single-sequence type.
AFG:AMPLitude
Sets (or queries) the AFG a mplitude in volts, peak to peak.
MSO54, MSO56, MSO58, MSO58LP Programmer 2-99
To Next Page
Loading...
Need help?
General
