Commands listed in alphabetical order
MEASUrement:
POPUlation:LIMIT:VALue
This command sets or queries the global population limit value for the
measurement.
Group
Measurement
Syntax
MEASUrement:POPU
lation:LIMIT:VALue <NR1>
MEASUrement:POPUlation:LI MIT:VALue?
Arguments
<NR1> is the current limit value.
Examples
MEASUREMENT:POPULATION:LI MIT:VALUE 2000 sets the population limit to
2000.
MEASUREMENT:POPULATION:LI MIT:VALUE? might return
:MEASUREMENT:POPULATION:L IMIT:VALUE 1000 indicating the
population limit value is 1000.
MEASUrement:REFLevels:ABSolute:FALLHigh
This command sets or queries the value used as the high reference level of the
falling edge when the measurement's ref level method is set to absolute.
Group
Measurement
Syntax
MEASUrement:REFLevels:ABS olute:FALLHigh <NR3>
MEASUrement:REFLevels:ABS olute:FALLHigh?
Arguments
<NR3> is the v alue used as the high reference level of the falling e dge when the
measurement's ref level method is set to absolute.
Examples
MEASUrement:REFLevels:ABS olute:FALLHigh 1.5 sets the high reference
level to 1.5 V.
MEASUrement:REFLevels:ABS olute:FALLHigh? might return
:MEASUREMENT:REFLEVELS:AB SOLUTE:FALLHIGH 1.0000 indicating the
high reference level is 1.0 V.
2-496 MSO54, MSO56, MSO58, MSO58LP Programmer
To Next Page
Loading...
Need help?
General
