Commands listed in alphabetical order
Examples
DISplay:REFFF
TView5:CURSor:VBArs:DELTa?
might return
:DISPLAY:REFFFTVIEW5:CURSO R:VBARS:DELTA 393.5558937038 906E+6
indicating the delta T cursor readout value is 393.556 MHz.
DISplay:REF
FFTView<x>:CURSor:VBArs:UNIts? (Query Only)
This command returns cursor A vertical units of the specified cursor in the
specified view.
Group
Cursor
Syntax
DISplay:REFFFTView<x>:CURS or:VBArs:UNIts?
Returns
Returns cursor A vertical units of the specified cursor in the specified view.
Examples
DISplay:REFFFTView5:CURSor :VBArs:UNIts? might return
:DISPLAY:REFFFTVIEW5:CURSO R:VBARS:UNITS "Hz" indicating the A
cursor vertical units are Hz.
DISplay:REFFFTView<x>:CURSor:WAVEform:AHPOSition? (Query Only)
This query-only command returns the value of the cursor A horizontal position.
Group
Cursor
Syntax
DISplay:REFFFTView<x>:CURS or:WAVEform:AHPOSition?
Examples
DISplay:REFFFTView1:CURSor :WAVEform:AHPOSition? might return
:DISPLAY:REFFFTVIEW1:CURSO R:WAVEFORM:AHPOSITION 9.9 1E+37.
DISplay:REFFFTView<x>:CURSor:WAVEform:APOSition
Sets or returns the waveform cursor A position in the specified plot view.
NOTE. In case of an XY plot, this command has no effect when used to set the
value. In the case of a bathtub plot, this command sets or queries the cursor A
vertical position. For all other plots, this command sets or queries the cursor
A horizontal position.
MSO54, MSO56, MSO58, MSO58LP Programmer 2-273
To Next Page
Loading...
Need help?
General
