To Next Page

To Previous Page

Commands listed in alphabetical order

Examples

MEASUREMENT:C

LOCKRECOVERY:DATAPATH

"C:/E:" sets the data path to C:/E:.

MEASUREMENT:CLOCKRECOVERY: DATAPATH? might return

:MEASUREMENT

:CLOCKRECOVERY:DATAPATH "C:/E"

MEASUrement:CLOCKRecovery:DATARate

This command sets or queries the global nominal data bit rate used when

nominal data rate clock recovery is used for the measurement. This will affect

measurements whose :MEASUrement:MEAS<x>:CLOCKRecovery:GLOBal

ﬂag is set to 1.

Group

Measurement

Syntax

MEASUrement:CLOCKRecovery: DATARate <NR3>

MEASUrement:CLOCKRecovery: DATARate?

Arguments

<NR3> is the global value for the Nominal data rate.

Examples

MEASUREMENT:CLOCKRECOVERY: DATARATE 2.0e+9 setsthedatarateforclock

recovery to 2.0 GHz.

MEASUREMENT:CLOCKRECOVERY: DATARATE? might return

:MEASUREMENT:CLOCKRECOVERY :DATARATE 2.5000E+9 indicating

the data rate is 2.5 GHz.

MEASUrement:CLOCKRecovery:EXPLICITCLOCKMODe

This command sets or queries the global explicit clock mode used when explicit

clo

ck recovery is used for the measurement. This w ill affect measurements whose

:MEASUrement:MEAS<x>:CLOCKRecovery:GLOBal ﬂag is set to 1.

Group

Measurement

Syntax

MEASUrement:CLOCKRecovery: EXPLICITCLOCKMODe {EDGE|P LL}

MEASUrement:CLOCKRecovery: EXPLICITCLOCKMODe?

Arguments

EDGE sets the clock mode to clock edge.

PLL sets the clock mode to phase locked loop.

MSO54, MSO56, MSO58, MSO58LP Programmer 2-395

Tektronix MSO56 User Manual

Questions and Answers: