Commands listed in alphabetical order
Syntax
SEARCH:SEARCH
<x>:TRIGger:A:SETHold:CLOCk: EDGE {FALL|RISe}
SEARCH:SEARCH<x>:TRIGger:A :SETHold:CLOCk:EDGE?
Arguments
FALL specifies the polarity as the clock falling edge.
RISe specifies the polarity as the clock rising edge.
Examples
SEARCH:SEARCH1:TRIGGER:A:S ETHOLD:CLOCK:EDGE FALL sets the
setup/hold trigger clock slope polarity for search 1 to falling edge.
SEARCH:SEARCH1:TRIGGER:A:S ETHOLD:CLOCK:EDGE? might return
:SEARCH:SEARCH1:TRIGGER:A: SETHOLD:CLOCK:EDGE RISE, indicating that
the setup/hold trigger clock slope polarity for search 1 is set to rising edge.
SEARCH:SEARCH<x>:TRIGger:A:SETHold:CLOCk:SOUrce
This command sets or queries the clock source setting for a setup/hold trigger
search to determine where to place a mark. The search number is specified by <x>.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger:A :SETHold:CLOCk:SOUrce
{CH<x>|CH<x>_D<x>|MATH<x>| REF<x>|REF<x>_D<x>}
SEARCH:SEARCH<x>:TRIGger:A :SETHold:CLOCk:SOUrce
SEARCH:SEARCH<x>:TRIGger:A :SETHold:CLOCk:SOUrce?
Arguments
CH<x> specifies an i
nput cha nnel as the edge source, where <x> = 1, 2, 3, 4, 5, 6,
7, or 8, depending on the number of channels in your instrument.
CH<x>_D<x> speci
fies a digital waveform as the setup and hold clock source
waveform for the specified search.
MATH<x> specifie
s the math waveform as the search source, where <x> = ≥1.
REF<x> specifies the reference waveform as the search source, where <x> = ≥1.
REF<x>_D<x> specifies a digital reference waveform as the setup and hold clock
source waveform for the specified search.
Examples
SEARCH:SEARCH1:TRIGGER:A:S ETHOLD:CLOCK:SOURCE MATH1 sets the
setup/hold trigger clock source setting for search 1 to MATH1.
SEARCH:SEARCH1:TRIGGER:A:S ETHOLD:CLOCK:SOURCE? might return
:SEARCH:SEARCH1:TRIGGER:A: SETHOLD:CLOCK:SOURCE CH1, indicating
that the setup/hold trigger clock source setting for search 1 is set to CH1.
MSO54, MSO56, MSO58, MSO58LP Programmer 2-731
To Next Page
Loading...
Need help?
General
