Commands listed in alphabetical order
Syntax
TRIGger:{A|B}
:SETHold:HOLDTime <NR3>
TRIGger:{A|B}:SETHold:HOL DTime?
Arguments
<NR3> is a floating point number that specifies the hold time setting, in seconds.
Positive values for hold time occur after the clock edge. Negative values occur
before the clock edge.
Examples
TRIGger:A:SETHold:HOLDTim e 3 .0E-3 sets the hold time for the setup and
hold trigger to 3 ms.
TRIGger:A:SETHold:HOLDTim e? might return
:TRIGGER:A:SETHOLD:HOLDTI ME 2.0000E-09 indicating that the current
hold time for the setup and hold trigger is 2 ns.
TRIGger:{A|B}:SETHold:SETTime
This command specifies the setup time for setup and hold violation triggering.
This command is equivalent to selecting Setup/Hold Setup from the Trig menu
and then setting the desired Setup Time.
Group
Trigger
Syntax
TRIGger:{A|B}:SETHold:SET Time <NR3>
TRIGger:{A|B}:SETHold:SET Time?
Arguments
<NR3> is a floating point number that specifies the setup time for setup and hold
violation triggering.
Examples
TRIGger:A:SETHold:SETTime 3.0E-6 specifies that the current setup time
for setup and hold trigger is 3 µs.
TRIGger:A:SETHold:SETTime ? might return
:TRIGGER:A:LOGIC:SETHOLD: SETTIME 2.0000E-09 indicating that the
current setup time for setup and hold trigger is 2 ns.
TRIGger:{A|B}:SETHOLDLogicval:{CH<x>|CH<x>_D<x>}
This command sets or queries whether the speci fi ed channel is included
(INCLude) or not included (DONTInclude) in the Setup & Hold trigger input
configuration. The channel number is specified by <x>.
2-864 MSO54, MSO56, MSO58, MSO58LP Programmer
To Next Page
Loading...
Need help?
General
