Commands listed in alphabetical order
BUS:B1:AUDIO:
WORDSEL:THRESHOLD?
might return
:BUS:B1:AUDIO:WORDSEL:THRE SHOLD 1.25 indicates th e Bus 1 audio word
select source threshold is set to 1.25 V.
BUS:B<x>:CA
N:BITRate
This command sets or queries the CAN bit rate. The bus number is specified by x.
If you select Custom, use BUS:B<x>:CAN:BITRate:VALue to set the bit rate.
Conditions
Requires option SR-AUTO.
Group
Bus
Syntax
BUS:B<x>:CAN:BITRate {RATE10K|RATE1 00K|RATE1M|RATE1 25K|
RATE153K|RATE20K|RATE25K|R ATE250K|RATE31K|RATE33K|
RATE400K|RATE50K|RATE500K| RATE62K| RATE68K|RATE800K |
RATE83K|RATE92K|CUSTom}
BUS:B<x>:CAN:BITRate?
Related Commands
BUS:B<x>:CAN:BITRate:VALue
Argumen
ts
Arguments specify the bit rate.
Examples
BUS:B1:CAN:BITRate RATE1M sets the CAN bit rate to 1 Mb.
BUS:B1:CAN:BITRate? might return :BUS:B1:CAN:BITRATE RATE500K,
indicating the CAN bit rate is set to 500 k.
BUS:B<x>:CAN:BITRate:VALue
This command sets or queries CAN bit rate when Custom is se lected by
BUS:B<x>:CAN:BITRate. The bus number is specified by x.
C
onditions
Requires option SR-AUTO.
Group
Bus
Syntax
BUS:B<x>:CAN:BITRate:VALue <NR3>
BUS:B<x>:CAN:BITRate:VALue ?
MSO54, MSO56, MSO58, MSO58LP Programmer 2-127
To Next Page
Need help?
General
