Commands listed in alphabetical order
If the CAN stand
ard is set for ISO CAN FD or Non-ISO CAN FD, and the trigger
data size is set to 8, the maximum value for the data offset will be 56 (64 - 8 = 56).
TRIGger:{A|B}:BUS:B<x>:CAN:DATa:QUALifier
This command sets the qualifier(<,>,=,≠, ≤, ≥) to be used when triggering
on a CAN bus signal. The trigger condition must be set to IDANDDATA or
DATa (using TRIGger:{A|B}:BUS:B<x>:CAN:CONDition). The bus number is
specified b
y<x>.
Conditions
Requires the SR-AUTO Triggering and Analysis application.
Group
Trigger
Syntax
TRIGger:{A|B}:BUS:B<x>:CAN :DATa:QUALifier
{LESS
than|MOREthan|EQual|UNEQual |LESSEQual|MOREEQual}
TRIGger:{A|B}:BUS:B<x>:CAN :DATa:QUALifier?
Arguments
LESSthan sets the oscilloscope to trigger when the data is less than the qualifier
value.
MOREthan sets the oscilloscope to trigger when the data is greater than the
qualifier value.
EQual sets the oscilloscope to trigger when the data is equal to the qualifier value.
UNEQual sets the oscilloscope to trigger when the data is not equal to the qualifier
value.
LESSEQual sets the oscilloscope to trigger when the data is less than o r equal
to the qualifier value.
MOREEQual sets the oscilloscope to trigger when the data is greater than or equal
to the qualifier value.
Examples
TRIGGER:A:BUS:B1:CAN:DATA: QUALIFIER LESSTHAN sets the oscilloscope
to trigger when the data is less than the qualifier value.
TRIGGER:A:BUS:B1:CAN:DATA: QUALIFIER? might return
:TRIGGER:A:BUS:B1:CAN:DATA :QUALIFIER LESSTHAN, indicating that the
oscilloscope is set to trigger when the data is less than the qualifier value.
MSO54, MSO56, MSO58, MSO58LP Programmer 2-773
To Next Page
Loading...
Need help?
General
