Commands listed in alphabetical order
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger: A:BUS:USB:CONDition
{DATAPacket|EOP|ERRor|HAN DSHAKEPacket|RESET|RESUME|
SPECIALPacket|SUSPEND|SYN C|TOKENPacket}
SEARCH:SEARCH<x>:TRIGger: A:BUS:USB:CONDition?
Arguments
DATAPacket specifies the search condition as Data Packet.
EOP spec ifies the search condition as End of Packet.
ERROR specifies the search condition as Error.
HANDSHAKEPacket specifies the search condition as Handshake Packet.
RESET specifies the search condition as Reset.
RESUME specifies the search condition as Resume.
SPECIALPacket specifies the search condition as Special Packet.
SUSPEND specifies the search condition as Suspend.
SYNC specifies the search condition as Sync.
TOKENPacket specifies the search condition as Token (Address) Packet.
Examples
SEARCH:SEARCH1:TRIGGER:A: BUS:USB:CONDITION EOP sets the search
condition for USB bu
s trigger search 1 to End of P acket.
SEARCH:SEARCH1:TRIGGER:A: BUS:USB:CONDITION? might return
:SEARCH:SEARCH1:
TRIGGER:A:BUS:USB:CONDITION SYNC
, indicating that
the search condition for USB bus trigger search 1 is set to Sync.
SEARCH:SEARCH<x>:TRIGger:A:BUS:USB:DATa:HIVALue
This command sets or q ueries the high binary data value used with In Range and
Out of Range qualifiers f or a USB bus search to determine where to place a mark.
The search number is specified by <x>. The search condition must b e set to DATA.
Conditions
Requires the SR-USB2 Serial Triggering and Analysis Application.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger: A:BUS:USB:DATa:HIVALue <Q String>
SEARCH:SEARCH<x>:TRIGger: A:BUS:USB:DATa:HIVALue?
2-702 MSO54, MSO56, MSO58, MSO58LP Programmer
To Next Page
Loading...
Need help?
General
