Commands listed in alphabetical order
Examples
SEARCH:SEARCH
1:TRIGGER:A:BUS:USB:DATA:SIZ E 1
sets the size of the
data string for USB bus trigger search 1 to 1 byte.
SEARCH:SEARCH1:TRIGGER:A:B US:USB:DATA:SIZE? might return
:SEARCH:SEARCH1:TRIGGER:A: BUS:USB:DATA:SIZE 3, indicating that the
size of the data string for USB bus trigger search 1 is set to 3 bytes.
SEARCH:SEARCH<x>:TRIGger:A:BUS:USB:DATa:TYPe
This command sets or queries the USB bus search type. The search number is
specified by <x>.
Conditions
Requires the SR-USB2 Serial Triggering and Analysis Application.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger:A :BUS:USB:DATa:TYPe
{ANY|DATA0|DATA1|DATA2|MDA TA}
SEARCH:SEARCH<x>:TRIGger:A :BUS:USB:DATa:TYPe?
Arguments
ANY specifies the data packet type as Any.
DATA0 specifi es the data packet type as DATA0.
DATA1 specifi es the data packet type as DATA1.
DATA2 specifi es the data packet type as DATA2.
MDATA specifiesthedatapackettypeasMDATA.
Examples
SEARCH:SEARCH1:TRIGGER:A:B US:USB:DATA:TYPE ANY
sets the data packet
type for USB bus trigger search 1 to ANY.
SEARCH:SEARCH2:TRIGGER:A:B US:USB:DATA:TYPE? might return
:SEARCH:SEARCH2:TRIGGER:A: BUS:USB:DATA:TYPE MDADA, indicating that
the packet type for USB bus trigger search 2 is set to MDATA.
SEARCH:SEARCH<x>:TRIGger:A:BUS:USB:DATa:VALue
This command sets or queries the binary data value used for a USB bus search to
determine where to place a mark. The search number is specified by <x>. The
search condition must be set to DATA.
Conditions
Requires the SR-USB2 Serial Triggering and Analysis Application.
MSO54, MSO56, MSO58, MSO58LP Programmer 2-705
To Next Page
Loading...
Need help?
General
