Tektronix MSO56 User Manual

Commands listed in alphabetical order
MEASUrement:M
ATH2:REFLevels:PERCent:FALLL ow?
might return
:MEASUREMENT:MATH2:REFLEVE LS:PERCENT:FALLLOW 10.000 0 indicating
the reference level is set to 10% of TOP.
MEASUrement
:MATH<x>:REFLevels:PERCent:FALLMid
This command sets or queries the percentage (where 100% is equal to TOP and
0% is equal to BASE) used to calculate the mid reference level of the falling
edge when t
he measurement ref level method is set to percent. The math number
is specified by x.
Group
Measurement
Syntax
MEASUrement:MATH<x>:REFLev els:PERCent:FALLMid <NR3>
MEASUrement:MATH<x>:REFLev els:PERCent:FALLMid?
Arguments
<NR3> is the percentage (where 50% is equal to MID) used to calculate the mid
reference level whe n the measurement Ref level method is set to Percent.
Examples
MEASUrement:MATH2:REFLevel s:PERCent:FALLMid 50 sets the reference
level to 50% of TOP.
MEASUrement:MATH2:REFLevel s:PERCent:FALLMid? might return
:MEASUREMENT:MATH2:REFLEVE LS:PERCENT:FALLMID 50.000 0 indicating
the reference level is set to 50% of TOP.
MEASUrement:MATH<x>:REFLevels:PERCent:HYSTeresis
This command sets or queries the percentage (where 100% is equal to MAX
and 0% is equal to MIN) used to calculate the hysteresis of the reference level
when the measurement ref level method is set to percent. The math number is
specified by x.
Group
Measurement
Syntax
MEASUrement:MATH<x>:REFLev els:PERCent:HYSTeresis <N R3>
MEASUrement:MATH<x>:REFLev els:PERCent:HYSTeresis?
Arguments
<NR3> is the hysteresis value used for the autoset.
MSO54, MSO56, MSO58, MSO58LP Programmer 2-417

Tektronix MSO56 Specifications

General

Brand	Tektronix
Model	MSO56
Category	Test Equipment
Language	English