Commands listed in alphabetical order
Examples
MEASUREMENT:G
ATING SC REEN
turns on measurement gating, using the left
and right edges of the screen.
MEASUREMENT:
GATING?
might return :MEASUREMENT:GATING CURSO R,
indicating that measurements are limitedtotheportionofthewaveformbetween
the vertical bar cursors.
MEASUremen
t:GATing:ACTive
This command sets or queries the global gating active level used for logic gating.
Group
Measurement
Syntax
MEASUrement:GATing:ACTive {HIGH|LOW}
MEASUrement:GATing:ACTive ?
Arguments
HIGH specifiesthegateisHIGH.
LOW specifies the gate is LOW.
Examples
MEASUREMENT:GATING:ACTIVE LOW specifies a lo
w gate.
MEASUREMENT:GATING:ACTIVE? might return
:MEASUREMENT:GATING:ACTIV E HIGH indicatin
g the gate is high.
MEASUrement:GATing:HYSTeresis
This command sets or queries the global gating hysteresis value used for logic
gating.
Group
Measurement
Syntax
MEASUrement:GATing:HYSTer esis <NR3>
MEASUrement:GATing:HYSTer esis?
Arguments
<NR3> is the g ating hysteresis.
2-406 MSO54, MSO56, MSO58, MSO58LP Programmer
To Next Page
Loading...
Need help?
General
