Commands listed in alphabetical order
setup context m
enu, and then choosing the desired Slope. This command is also
equivalent to pressing the front-panel Slope button.
Group
Trigger
Syntax
TRIGger:{A|B}:EDGE:SLOpe {RISe|FALL|EI Ther}
TRIGger:{A|B}:EDGE:SLOpe?
Related Commands
TRIGger:{A|B}:EDGE:SOUrce, TRIGger:{A|B}:EDGE:COUPling,
TRIGger:B:STAT E
Arguments
RISe specifies to trigger on the rising or positive edge o f a signal.
FALL specifies to trigger on the falling or negative edge of a signal.
EITHER specifies to trigger on either the rising or falling edge of a signal.
Examples
TRIGGER:A:EDGE:SLOPE RISE sets the A edge trigger slope to positive, which
triggers on the rising edge of the signal.
TRIGGER:A:EDGE:SLOPE? might return :TRIGGER:A:EDGE:SLOPE FALL,
indicating that the A edge trigger slope is negative.
TRIGger:{A|B}:EDGE:SOUrc
e
This command sets or queries the source for the edge trigger. For instruments that
have an Auxiliary Input (such as the MSO58LP), AUXiliary can be selected
as trigger source.
Group
Trigger
Syntax
TRIGger:{A|B}:EDGE:SOUrce {CH<x>|CH<x> _D<y>|LINE|AUXi liary}
TRIGger:{A|B}:EDGE:SOUrce ?
Related Commands
TRIGger:{A|B}:EDGE:SLOpe, TRIGger:{A|B}:EDGE:COUPling,
TRIGger:B:STAT E
Arguments
CH<x> specifies an analog channel as the edge trigger source.
CH<x>_D<y> specifies a digital channel as the edge trigger s ource.
LINE specifies AC line voltage, and is a valid source when B trigger is inactive.
2-850 MSO54, MSO56, MSO58, MSO58LP Programmer
To Next Page
Loading...
Need help?
General
