Tektronix MSO56 User Manual

Commands listed in alphabetical order
Syntax
BUS:B<x>:USB:
BITRate { FULL|HIGH|LOW}
BUS:B<x>:USB:BITRate?
Arguments
FULL indicates the bit rate is 12 Mbps.
HIGH indicates the bit rate is 480 Mbps.
LOW indicates the bit rate is 1.5 Mbps.
Examples
BUS:B1:USB:BITRATE FULL sets the bit rate to 12 Mbps.
BUS:B1:USB:BITRATE? might return :BUS:B1:USB:BITRATE LOW, indicating
that the bit rate is 1.5 Mbps.
BUS:B<x>:USB:DATAMINUSTHRESHold
This comma nd sets or queries the USB D- source threshold for the specified
bus. The bus is specified by x.
Conditions
Requires option SR-USB2.
Group
Bus
Syntax
BUS:B<x>:USB:DATAMINUSTHR ESHold <NR3>
BUS:B<x>:USB:DATAMINUSTHR ESHold?
Arguments
<NR3> is the Minus threshold.
Examples
BUS:B1:USB:DATAMINUSTHRES Hold 50.0e-3 setsthethresholdto50.0mV.
BUS:B1:USB:DATAMINUSTHRES Hold? might return
:BUS:B1:USB:DATAMINUSTHRE SHOLD 0.0E+0 indicating the threshold
is set to 0.0 V.
BUS:B<x>:USB:DATAPLUSTHRESHold
This command sets or queries the USB D + source threshold for the specified
bus. The bus is specified by x.
Conditions
Requires option SR-USB2.
2-178 MSO54, MSO56, MSO58, MSO58LP Programmer

Tektronix MSO56 Specifications

General

Brand	Tektronix
Model	MSO56
Category	Test Equipment
Language	English