Tektronix MSO56 User Manual

Commands listed in alphabetical order
FordIbydtmeas
urement, the parameter is “DIBYDT”.
For SOA measurement, the parameter is “SOAHITSCNT”.
For Line Ripple measurement, the parameters are “LRIPRMS” | “LRIPPKPK”.
For Switching Ripple measurement, the p arameters are “SWRIPRMS” |
“SWRIPPKPK”.
For Cycle Period measurement, the parameters is “PRIOD”.
For Cycle Frequency measurement, the parameters is “FREQ”.
For Positive Duty Cycle measurement, the parameters is “PDUTY”.
For Negat
ive Duty Cycle measurement, the parameters is “NDUTY”.
For Positive Pulse Width measurement, the parameters is “PPULSE”.
For Negative Pulse Width measurement, the parameters is “NPULSE”.
For C ycle Amplitude measurement, the parameters is “AMPL”.
For Cycle Peak–Peak measurement, the parameters is “PKPK”.
For Cycle Top measurement, the parameters is “HIGH”.
For Cy
cle Base measurement, the parameters is “LOW”.
For Cycle Max measurement, the parameters is “MAX”.
For Cycle Min measurement, the parameters is “MIN”.
Examples
POWer:POWer1:RESUlts:CURR entacq:PK2PK? “TONLoss” might return
9.91E+37, indicating the peak-to-peak value of Ton Energy for all acquisitions.
POWer:POWer<x>:RESUlts:ALLAcqs:POPUlation? (Query Only)
This command queries the population (number of complete cycles) of all
acquisitions for the measurement parameter in the specified power measurement
badge. The power measurement badge is specified by x.
Conditions
Requires option 5-PWR, SUP5-PWR, or 5-PS2.
Group
Power
Syntax
POWer:POWer<x>:RESUlts:AL LAcqs:POPUlation? <QString>
2-566 MSO54, MSO56, MSO58, MSO58LP Programmer

Tektronix MSO56 Specifications

General

Brand	Tektronix
Model	MSO56
Category	Test Equipment
Language	English