Commands listed in alphabetical order
SEARCH:SEARC
H<x>:TRIGger:A:BUS:RS232C:DATa:SIZe
This command sets or queries the length of the data string in bytes to be used
for an RS232 bus search to determine where to place a mark when the search
condition is
Data. The search number is specified by <x>.
Conditions
Requires the SR-COMP Serial Triggering and Analysis Application.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger:A :BUS:RS232C:DATa:SIZe <NR 3>
SEARCH:SEARCH<x>:TRIGger:A :BUS:RS232C:DATa:SIZe?
Arguments
<NR3> is the number of bits
per word in the data string, from 1 to 8.
Examples
SEARCH:SEARCH1:TRIGGER:A:B US:RS232C:DATA:SIZE 1 sets the number
of bits per word in RS232C bus trigger search 1 data string to 1.
SEARCH:SEARCH2:TRIGGER:A:B US:RS232C:DATA:SIZE? might return
:SEARCH:SEARCH2:TRIGGER:A: BUS:RS232C:DATA:SIZE 8, indicating that
the bits per word for RS232C bus trigger search 2 is set to 8.
SEARCH:SEARCH<x>:TRIGger:A:BUS:RS232C:DATa:VALue
This command sets or queries the data string used for the specified RS232C bus
trigger search to determine where to place a mark. The search condition must be
Data. The search number is specified by <x>.
Conditions
Requires the SR-COMP Serial Triggering and Analysis Application.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger:A :BUS:RS232C:DATa:VALue <Q String>
SEARCH:SEARCH<x>:TRIGger:A :BUS:RS232C:DATa:VALue?
Arguments
<QString> specifies the value of the data string. The valid characters are 0, 1,
and X for values in binary format; and A-F, 0-9, and X for values in hexadecimal
format.
MSO54, MSO56, MSO58, MSO58LP Programmer 2-697
To Next Page
Loading...
Need help?
General
