Commands listed in alphabetical order
DIAg:RESUlt:
LOG? (Query Only)
This query returns the test Pass/Fail status of each diagnostic area. It does not
return the o verall status.
Group
Self Test
Syntax
DIAg:RESUlt:LOG?
Returns
The status of the diagnostic area.
Examples
DIAG:RESULT:LOG? might return :DIAG:RESULT:LOG
"PASS--IO,PASS--ANALOG,PAS S--SYSTEM,PASS--ASIC,PASS--ACQ,
PASS--SIGNAL,PASS--MEMORY"
indicating the diagnostics result stored in
the log.
DIAg:SELect (No Query Form)
This command selects or queries an available diagnostic area.
Group
Self Test
Syntax
DIAg:SELect {ALL|IO|ANALOG|SYSTEM|ASIC | ACQ|SIGNAL|MEMORY}
DIAg:SELect?
Arguments
The argument is the desired diagnostic area.
Examples
DIAG:SELECT IO will select the IO group.
DIAg:STATE (No Query Form)
This command starts or aborts Self Test. Abort happens after group under test
completes.
Group
Self Test
Syntax
DIAg:STATE {EXECute|ABOrt}
MSO54, MSO56, MSO58, MSO58LP Programmer 2-225
To Next Page
Loading...
Need help?
General
