Commands listed in alphabetical order
POWer:POWer<
x>:RESUlts:CURRentacq:STDDev? (Query Only)
This command queries the standard deviation value of the current acquisition for
the measurement parameter in the spe cified power measurement badge. The
power measur
ement badge is specified by x.
Conditions
Requires option 5-PWR, SUP5-PWR, or 5-PS2.
Group
Power
Syntax
POWer:POWer<x>:RESUlts:CUR Rentacq:STDDev?<QString>
Arguments
<QString> = parameters of the mea surements. The details of the parameters for
the Power measurements are listed below:
For Power Quality measurement, the parameters are "TRUEPWR" | "APPPWR"
| "REPWR" | "PWRFACTOR" | "PHASE" | "PWRFREQ" | "ICFACTOR" |
"VCFACTOR" | "IRMS" | "VRMS".
For Switching Loss measurement, the parameters are "TONENRG" | "TONLOSS"
| "TOFFENRG" | "TOFFLOSS" | "CONDENRG" | "CONDLOSS" | "TTLLOSS" |
"TTLENRG".
For dV by dt m easurement, the parameter is “DVBYDT”.
FordIbydtmeasurement,theparameteris“DIBYDT”.
For SOA measurement, the p arameter is “SOAHITSCNT”.
For Line Ripple measurement, the parameters are “LRIPRMS” | “LRIPPKPK”.
For Switching Ripple measurement, the parameters are “SWRIPRMS” |
“SWRIPPKPK”.
For Cycle Period measurement, the parameters is “PRIOD”.
For Cycle Frequency meas urement, the parameters is “FREQ”.
For Positive Duty Cycle measurement, the parameters is “PDUTY”.
For Negative Duty Cycle measurement, the parameters is “NDUTY”.
For Positive Pulse Width measurement, the parameters is “PPULSE”.
For Negative Pulse Width measurement, the p arameters is “NPULSE”.
For Cycle Amplitude measurement, the parameters is “AMPL”.
For Cycle Peak–Peak measurement, the parameters is “PKPK”.
For Cycle Top measurement, the parameters is “HIGH”.
MSO54, MSO56, MSO58, MSO58LP Programmer 2-579
To Next Page
Loading...
Need help?
General
