Commands listed in alphabetical order
CH<x>:PRObe:
UNIts? (Query Only)
This query-only command returns a string describing the units of measure for the
probe attached to the specified channel. The channel is specified by x.
Group
Vertical
Syntax
CH<x>:PRObe:UNIts?
Related Commands
CH<x>:PROBEFunc:EXTUnits
Examples
CH4:PROBE:UNITS? might return :CH4:PROBE:UNITS "V", indicating that the
units of measure for the probe attached to Channel 4 are volts.
CH<x>:PROBECal? (Query Only)
This query-only command returns the probe c alibration state for the specified
channel. The channel is specified by x.
Group
Vertical
Syntax
CH<x>:PROBECal?
Returns
This query will return one of the following:
Failed signifies that the probe calibration has failed for the selected channel.
Default signifies that the p robe calibration has not yet been run for the
selected channel.
Passed signifies the probe calibration h as passed for the selected channel.
Running signifies the probe calibration is running.
Examples
CH2:PROBECAL? might return :CH2:PROBECAL PASSED indicating that the
probe calibration has passed for Channel 2.
CH<x>:PROBECOntrol
This command sets or queries multirange probe range-control policy preference of
the probe that is attached to CH<x>. The channel number is specified by <x>.
2-200 MSO54, MSO56, MSO58, MSO58LP Programmer
To Next Page
Loading...
Need help?
General
