Commands listed in alphabetical order
Syntax
*CLS
Related Commands
DESE, *ESE, *ESR?, EVENT?, EVMsg?, *SRE, *STB?
Examples
*CLS clears the instrument status data structures.
CONFIGuration:ANALOg:BANDWidth? (Query Only)
This command queries the maximum licensed bandwidth of the instrument.
Group
Vertical
Syntax
CONFIGuration:ANALOg:BAND Width?
Returns
The maximum licensed bandwidth of the instrument is returned.
Examples
CONFIGuration:ANALOg:BAND Width? might return
:CONFIGURATION:ANALOG:BAN DWIDTH 2.0000E+9 indicating the
bandwidth is 2.0 GHz.
CURVe
This command transfers waveform data to and from the instrument. Each
waveform that is transferred has an associated waveform preamble that contains
information such as data format and scale.
The
CURVe? query transfers data from the instrument. The data source is specified
by the DATa:SOUrce command. The first and last data points are spec ified by the
DATa:STARt and DATa:STOP commands.
The
CURVe command transfers waveform data to the instrument. The data is
stored in the reference memory location specified by , starting with the data point
specified by DATa:STARt. Only one waveform can be transferred at a time. The
waveform will only be displayed if the reference is displayed.
For digital sources, CH<x>_D<n> or CH<x> _DALL, when the :DATa:WIDth
is 1, the returned data is state only. When the :DATa:WIDth is 2, the returned
data is transition data with 2 bits per digital channel representing the transition
information as follows:
2-212 MSO54, MSO56, MSO58, MSO58LP Programmer
To Next Page
Loading...
Need help?
General
