To Next Page

To Previous Page

Commands listed in alphabetical order

For Positive Du

ty Cycle measurement, the parameters is “PDUTY”.

For Negative Duty Cycle measurement, the para meters is “NDUTY”.

For Positive Pulse Width measurement, the parameters is “PPULSE”.

For Negative Pulse Width measurement, the parameters is “NPULSE”.

For C ycle Amplitude measurement, the parameters is “AMPL”.

For Cycle Peak–Peak measurement, the parameters is “PKPK”.

For Cycle Top measurement, the parameters is “HIGH”.

For Cycle Base measurement, the parameters is “LOW”.

For Cycle Max measurement, the parameters is “MAX”.

For Cycle Min measurement, the parameters is “MIN”.

Examples

POWer:POWer1:RESUlts:CURR entacq:MINimum? "TruePwr" might

return 5.1307829019093E–9, indicating the minimum value of true power for

the curr

ent acquisition.

POWer:POWer<x>:RESUlts:CURRentacq:PK2PK? (Query Only)

This command queries the peak-to-peak value of the current acquisition for the

measurement parameter in the speciﬁed power measurement badge. The pow

measurement badge is speciﬁed by x.

Conditions

Requires option 5-PWR, SUP5-PWR, or 5-PS2.

Group

Power

Syntax

POWer:POWer<x>:RESUlts:CU RRentacq:PK2PK? <QString>

Arguments

<QString> = parame ters of the measurements. The details of the p arameters for

the Power measurements are listed below:

For Power Quality measurement, the parameters are "TRUEPWR" | "APPPWR"

"VCFACTOR" | "IRMS" | "VRMS".

For Switching Loss measurement, the parameters are "TONENRG" | "TONLOSS"

"TTLENRG".

For dV by dt m easurement, the parameter is “DVBYDT”.

2-574 MSO54, MSO56, MSO58, MSO58LP Programmer

Tektronix MSO56 User Manual

Questions and Answers: