Tektronix MSO56 User Manual

Commands listed in alphabetical order
Syntax
SEARCH:SEARCH
<x>:TRIGger:A:BUS:USB:SPLIT: ET:VALue
{BULK|CONTROL|NOCARE|INTE RRUPT|ISOchronous}
SEARCH:SEARCH<x>:TRIGger: A:BUS:USB:SPLIT:ET:VALue?
Arguments
BULK specifies the Endpoint Type value as Bulk (10).
CONTROL specifies the Endpoint Type value as Control (00).
NOCARE specifies the Endpoint Type value as Don’t C are.
INTERRUPT specifies the Endpoint Type value as Interrupt (11).
ISOchronous specifies the Endpoint Type value as Isochronous (01).
Examples
SEARCH:SEARCH1:TRIGGER:A: BUS:USB:SPLIT:ET:VALUE BU LK sets the
Endpoint Type value for USB bus trigger search 1 to Bulk.
SEARCH:SEARCH1:TRIGGER:A: BUS:USB:SPLIT:ET:VALUE? might return
:SEARCH:SEARCH1:TRIGGER:A :BUS:USB:SPLIT:ET:VALUE D ONTCARE,
indicating that the Endpoint Type value for USB bus trigger search 1 is set to
DONTCare.
SEARCH:SEARCH<x>:TRIGger:A:BUS:USB:SPLIT:HUB:VALue
This command sets or queries the binary hub address value to be used when
searching on a USB bus signal. The search number is specified by <x>. The
search condition must be set to Special with packet type SPLIT.
Conditions
Requires the SR-USB2 Serial Triggering and Analysis Application.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger: A:BUS:USB:SPLIT:HUB:VALue <QString>
SEARCH:SEARCH<x>:TRIGger: A:BUS:USB:SPLIT:HUB:VALue?
Arguments
<QString> specifies the hub address. The valid characters are .
Examples
SEARCH:SEARCH1:TRIGGER:A: BUS:USB:SPLIT:HUB:VALUE " 1001" sets
the hub address to "XXX1001".
SEARCH:SEARCH1:TRIGGER:A: BUS:USB:SPLIT:HUB:VALUE? might return
:SEARCH:SEARCH1:TRIGGER:A :BUS:USB:SPLIT:HUB:VALUE "XX" (for
binary format), indicating that the hub address for the USB bus trigger search
on split token field is "XX".
2-710 MSO54, MSO56, MSO58, MSO58LP Programmer

Tektronix MSO56 Specifications

General

Brand	Tektronix
Model	MSO56
Category	Test Equipment
Language	English