Tektronix MSO56 User Manual

Commands listed in alphabetical order
MEASUrement:
MEAS<x>:EDGEIncre
This command sets or queries the edge increment value for the measurement.
Measurements are specified by x.
Group
Measurement
Syntax
MEASUrement:MEAS<x>:EDGEIn cre <NR3>
MEASUrement:MEAS<x>:EDGEIn cre?
Arguments
<NR3> is the measurements edge increment value.
Examples
:MEASUREMENT:MEAS2:EDGEINC RE? might return
:MEASUREMENT:MEAS2:EDGEINC RE 1.0000 indicating the edge increment
value is set to 1.0000.
MEASUrement:MEAS<x>:EDGES:FROMLevel
This command sets or queries the 'from level' edge for the measurement.
Measurements are specified by x.
Group
Measurement
Syntax
MEASUrement:MEAS<x>:EDGES: FROMLevel {MID|LOW|HIGH}
MEASUrement:MEAS<x>:EDGES: FROMLevel?
Arguments
MID specifies the MID level.
HIGH specifies the HIGH level.
LOW specifies the LOW level.
Examples
MEASUrement:MEAS1:EDGES:FR OMLevel HIGH set the from level to the high
level
MEASUrement:MEAS1:EDGES:FR OMLevel? might return
:MEASUREMENT:MEAS1:EDGES:F ROMLEVEL LOW indicating the from
level is the low level.
MSO54, MSO56, MSO58, MSO58LP Programmer 2-443

Tektronix MSO56 Specifications

General

Brand	Tektronix
Model	MSO56
Category	Test Equipment
Language	English