Commands listed in alphabetical order
MEASUrement:
GATing:SEARCHSource
This command sets or queries the global gating search source when the gating
type is search.
Group
Measurement
Syntax
MEASUrement:GATing:SEARCH Source SEARCH1
MEASUrement:GATing:SEARCH Source?
Arguments
Argument is the search source.
Examples
MEASUREMENT:GATING:SEARCH SOURCE SEARCH1 set the search sourc e to
search 1.
MEASUREMENT:GATING:SEARCH SOURCE? might return
:MEASUREMENT:GATING:SEARC HSOURCE UNDEFINED indicating the
search source is not defined.
MEASUrement:INTERp
This command sets or queries the interpolation mode used to locate edge crossings.
Group
Measurement
Syntax
MEASUrement:INTERp {AUTO|SINX|LINea r}
MEASUrement:INTERp?
Arguments
AUTO automatically selects the interpolation m ode.
SINX specifies sin(x)/x interpolation, where acquired points are fittoacurve.
LINear specifies linear interpolation, where a cquired points are connected with
straight lines.
Examples
MEASUREMENT:INTERP SINX set the interpolation mode to sin(x)/x.
MEASUREMENT:INTERP? might return :MEASUREMEN T:INTERP AUTO indicating
the interpolation mode is auto.
2-408 MSO54, MSO56, MSO58, MSO58LP Programmer
To Next Page
Loading...
Need help?
General
