Commands listed in alphabetical order
Arguments
LESSthan sets t
he cycle count qualifier to less than.
MOREthan sets the cycle count qualifier to more than.
EQual sets the cycle count qualifier to equal.
UNEQual sets the cycle count qualifier to not equal.
LESSEQual sets the cycle count qualifier to less than or equal.
MOREEQual sets the cycle count qualifier to greater than or equal.
INrange se
ts the cycle count qualifier to in range.
OUTrange sets the cycle count qualifier to out of range.
Examples
TRIGGER:A:BUS:B1:FLEXRAY:C YCLECOUNT:QUALIFIER LESST HAN sets the
cycle count qualifier to LESSTHAN.
TRIGGER:A:BUS:B1:FLEXRAY:C YCLECOUNT:QUALIFIER? might return
TRIGGER:A:BUS:B1:FLEXRAY:C YCLECOUNT:QUALIFIER EQUAL indicating
that the cycle count qualifier is set to EQUAL.
TRIGger:{A|B}:BUS:B<x>:FLEXray:CYCLEcount:VALue
This command specifies the low value when triggering on the FlexRay bus cycle
count field. (Use TRIGger:{A|B}:BUS:B<x>:FLEXray:CYCLEcount:HIVALue
to set the upper value.) The trigger condition must be set to CYCLEcount (using
TRIGger:{A|B}:BUS:B<x>:FLEXray:CONDition).The bus number is specified
by <x>.
Conditions
Requires the SR-AUTO Triggering and Analysis application.
Group
Trigger
Syntax
TRIGger:{A|B}:BUS:B<x>:FLE Xray:CYCLEcount:VALue <QS tring>
TRIGger:{A|B}:BUS:B<x>:FLE Xray:CYCLEcount:VALue?
Arguments
<QString> is a quoted binary data string that represents the cycle count low
value.
Examples
TRIGGER:A:BUS:B1:FLEXRAY:C YCLECOUNT:VALUE "11001101" sets the
cycle count value to 11001101.
MSO54, MSO56, MSO58, MSO58LP Programmer 2-795
To Next Page
Loading...
Need help?
General
