Tektronix MSO56 User Manual

Commands listed in alphabetical order
SEARCH:SEARCH
1:TRIGGER:A:BUS:ARINC429A:DA TA:HIVALUE?
might
return "XXXXXXXXXXXXXXXXXXX", indic ating that the value is
XXXXXXXXXXXXXXXXXXX.
SEARCH:SEAR
CH<x>:TRIGger:A:BUS:ARINC429A:DATa:QUALifier
This command sets or queries the qualifier to be used when searching on data in
the DATA field for an ARINC429 bus signal. The search number is specified by
x. The sear
ch condition must be set to DATa or LABELANDDATA.
Conditions
Requires the SR-AERO Triggering and Analysis application.
Group
Search and Mark
Syntax
SEARCH:SEARCH<x>:TRIGger: A:BUS:ARINC429A:
DATa:QUALifier
{EQual|UNEQual|LESSthan|MOREthan
|LESSEQual|MOREEQual|INrange|OUTrange}
SEARCH:SEARCH<x>:TRIGger: A:BUS:ARINC429A:DATa:QUALifier?
Arguments
Argumentsaretheavailabledataqualifiers.
NOTE. The search qualifier only applies to the bits defined as the data field via the
bus data field format specifier (using
BUS:B<x>:AR INC429A:DATAFORmat ).
Examples
SEARCH:SEARCH1:TRIGGER:A: BUS:ARINC429A:DATA:QUALIFIER
LESSTHAN
sets the d ata qualifier to less than.
SEARCH:SEARCH1:TRIGGER:A: BUS:ARINC429A:DATA:QUALIFIER? might
return EQUAL, indicating that the data qualifier is set to equal.
SEARCH:SEARCH<x>:TRIGger:A:BUS:ARINC429A:DATa:VALue
This command sets or queries the low value when searching on an ARINC429
data field. The search number is specified by x. The search condition must be set
to DATa or LABELANDDATA.
Conditions
Requires the SR-AERO Triggering and Analysis application.
Group
Search and Mark
2-632 MSO54, MSO56, MSO58, MSO58LP Programmer

Tektronix MSO56 Specifications

General

Brand	Tektronix
Model	MSO56
Category	Test Equipment
Language	English