Tektronix MSO56 User Manual

Commands listed in alphabetical order
Arguments
<QString> is th
e label value.
Examples
TRIGGER:A:BUS:B1:ARINC429A :SDI:VALUE "X0" sets the value to X0.
TRIGGER:A:BUS:B1:ARINC429A :SDI:VALUE? might return "XX", indicating
that the value is XX.
TRIGger:{A|B}:BUS:B<x>:ARINC429A:SSM:VALue
This command sets or queries the label value when triggering on an ARINC429
SSM field. The bus number is specified by x. The trigger condition must be
set to DATa or LABELANDDATA, and the data format must be set to DATA
or SDIDATA.
Conditions
Requires the SR-AERO Triggering and Analysis application.
Group
Trigger
Syntax
TRIGger:{A|B}:BUS:B<x>:ARI NC429A:SSM:VALue <QString>
TRIGger:{A|B}:BUS:B<x>:ARI NC429A:SSM:VALue?
Arguments
<QString> is the label value.
NOTE. The SSM field is only present when the selected data field format is DATA
or SDIDATA (using
BUS:B<x>:ARI NC429A:DATAFORmat ). Also, the stored
QString is reset to its default value whenever the data field format is changed.
Examples
TRIGGER:A:BUS:B1:ARINC429A :SSM:VALUE "X0" sets the value to X0.
TRIGGER:A:BUS:B1:ARINC429A :SSM:VALUE? might return "XX", indicating
that the value is XX.
TRIGger:{A|B}:BUS:B<x>:AUDio:CONDition
This command sets the condition (word select, start of frame, or m atching data)
to be used when triggering on an audio bus signal. The bus number is specified
by <x>.
Conditions
Requires the SR-AUDIO Triggering and Analysis application.
MSO54, MSO56, MSO58, MSO58LP Programmer 2-765

Tektronix MSO56 Specifications

General

Brand	Tektronix
Model	MSO56
Category	Test Equipment
Language	English