Commands listed in alphabetical order
Examples
MEASUrement:M
EAS1:BIN 2
sets the bin count to 2.
MEASUrement:MEAS1:BIN? might return :MEASUREMENT:MEAS 1:BIN 1
indicating th
e bin count is 1.
MEASUrement:MEAS<x>:BITCfgmode
This command sets or queries whether the measurement returns the mean or
mode statis
tic result when the measurement type is bit amplitude/high/low.
Measurements are specified by x.
Group
Measurement
Syntax
MEASUrement:MEAS<x>:BITCfg mode {MEAN|MODE}
MEASUrement:MEAS<x>:BITCfg mode?
Arguments
MEAN specifies that the measurement returns results for each bit.
MODE specifies that the measurement returns the mode of its results.
Examples
MEASUrement:MEAS1:BITCfgmo de MODE specifies that the measurement
returns the mode of its results.
MEASUrement:MEAS1:BITCfgmo de? might return
:MEASUREMENT:MEAS1:BITCFGM ODE MEAN indicating the configuration mode
is set to MEAN.
MEASUrement:MEAS<x>:BITEnd
This command sets or queries the bit end as a percentage of the unit interval.
Measurements are specified by x.
Group
Measurement
Syntax
MEASUrement:MEAS<x>:BITEnd <NR3>
MEASUrement:MEAS<x>:BITEnd ?
Arguments
<NR3> is the bit end.
MSO54, MSO56, MSO58, MSO58LP Programmer 2-423
To Next Page
Loading...
Need help?
General
